x-wing fighter

written by tammy

It’s true, one of my young friends is a little Star Wars obsessed, thereby explaining the influx of Star Wars themed crafts on the site. This one, of course, was recycle-bin inspired… with much of the art direction by a 4 year old boy.

We used a water bottle, 4 toilet paper rings, a styrofoam supermarket tray, some pipe cleaners and masking tape. Lots and lots of masking tape!

Using a sharp knife or a craft knife, have an adult cut 2 seat holes, one for your pilot and one for the co-pilot (see last pic). Using masking tape, cover the sharp plastic edges where the bottle was cut.

Cut the styrafoam tray into 4 wings of similar size. Loop a piece of pipe cleaner through the end of each wing, and twist together to form lasers.

Attach the toilet paper rings to the bottle using masking tape, as seen below. Then add the wings.

Cover the entire ship with masking tape, then add accents & details using stickers or permanent marker.

After much play with this ship (notice the broken wings) I was told that R2D2 needed a seat… so make sure you give R2D2 a seat!! Also, to make sure our Jedi did not fall into the bottle, we taped a small piece of pipe cleaner inside to form a seat that he straddles. You can see part of it in the last two images.

Share

styrofoam relief print

written by tammy

foam print

Using the trash twice is a very special skill… Here’s another really addictive project that reuses those styrofoam trays they strap our food to in the supermarkets.

Printing is a fun & easy way to make your own birthday party invitations, holiday and thank you cards. Styrofoam relief printing is great for young kids because no major cutting is required, only drawing and tracing. Scribble-scrabble even looks cool when it’s printed with this technique.

You Need:

  • a rubber brayer
  • water-soluble block printing ink
  • styrofoam tray
  • old magazine
  • aluminum foil
  • paper & pencil
  • recycled paper to print on

  1. Start by cutting off the rounded corners of your styrofoam tray so that it lays flat. This is the size of the surface you have to work with.
  2. On a piece or scratch paper, draw a sketch to use for your print. Tip: Keep it simple… tiny details do not show up very well with this type of print.
  3. Tape your drawing onto the foam plate. Transfer the image to the foam by tracing over your picture using a firm and steady pressure. When you have gone over the whole image, remove the tape and picture. You will need to go over the foam plate one more time with your pencil to carefully carve out the details.
  4. Get your work area ready! Cover your work area. Wrap an old magazine with aluminum foil to make a palate for your ink. Squeeze a finger sized amount onto your palate and roll back and forth and up and down with your rubber brayer until it is evenly covered.
  5. Roll ink onto your foam printing plate.
  6. Flip printing plate over onto a clean sheet of recycled paper.
  7. Press firmly all around. Then carefully peel the paper off.
  8. Allow to dry.

To use a new color, wash the brayer and printing plate. Re-cover the same magazine with a new layer of foil, and apply new printing ink.

Clean-up is easy, just wash right away with soap and water! Wash your printing plate and you can use it again and again.

Here are a few more pictures of what we did…

printing pics

Related Posts Plugin for WordPress, Blogger...
Share

find a project

sponsors

country kitchen in the city

Superstorm Sandy Web Banner
Follow Me on Pinterest

bloglovin

Save Handmade Toys